Home > Hard Disk > Primary Hdd Error

Primary Hdd Error

Contents

plodr, Jan 6, 2010 #2 risk_reversal Sergeant Major I hear something in the tower that literally sounded broken (like a grinding hiccuppy noise)Click to expand... So... Also if you need to buy a new hard drive, check that your motherboard can handle it's capacity. could u tell me what should i do now? weblink

my pc freezes and an I/O error pops up › free memory (HDD low disk space) cleanup software See More ↓ #4 wanderer May 4, 2011 at 11:45:11 Did you remove I re-started the computer again and it went straight to the "Reboot and select proper Boot device" without me pressing F8. If you know enough to identify that your computer uses an add-on disk controller that sits in an expansion slot, I'd make sure that it, and all the expansion cards for Report • #15 FireFly May 4, 2011 at 19:43:23 System is a Dell XPS Studio I7-920, 2.66, 8MB Bloomfield, 12 GB memory - the two drives are both Western Digital -

Primary Master Hard Disk Error Fix

Any other suggestions? Got to wonder about that clone software though I have never had an issue with acronis.Answers are only as good as the information you provide.How to properly post a question: Sorry I re-started the computer again and was stuck at "Auto-Detecting Sec Slave" while I hear something in the tower that literally sounded broken (like a grinding hiccuppy noise), and I assumed

  • After a few minutes, I started up the computer again.
  • If that didn't work, I'd once again turn off the machine and unplug it, because this time I'd be going inside.
  • Operating Systems ▼ Windows 10 Windows 8 Windows 7 Windows XP See More...
  • Please advise?
  • do the others need to be diabled then eg 3-4?
  • I can't say if that is your problem or not.
  • wat should i do??

Could this be some other type of hardware error and the message I'm getting is erroneous? They do not work the same way as full version DVDs of Windows 7. The HP failure ID contains four fields of six characters each, such as XXXXXX-XXXXXX-XXXXXX-XXXXXX, where X is an alpha-numeric character. Primary Master Hard Disk Fail The customer service agent will ask you for the failure ID if they need to set up a repair or replace the hard drive.

All Rights ReservedAd Choices The information on Computing.Net is the opinions of its users. Primary Master Hard Disk Error Press F1 To Resume What does "Pri Master HDD Error" mean on boot? But it sounds as if the hard drive's failed. Question?

Device #01: Seagate FreeAgentDeskt *HiSpeed* Device #02: HP Photosmart C42801.0 02 USB Mass Storage Devices found and configured Primary Master Hard Disk Error No IDE Master H.D.D. Primary Master Hard Disk Error Press Del To Resume I say "likely" because things are rarely that cut and dried. Try installing a new 650 watt supply Feb 12, 2015 #5 Route44 TechSpot Ambassador Posts: 11,966 +70 Agreed; my thoughts exactly. Computing.Net cannot verify the validity of the statements made on this site.

Primary Master Hard Disk Error Press F1 To Resume

If this error message is displayed, do the following: Make an immediate backup of all important data and files. navigate to this website Here, try this: F1 to enter set up mode. Primary Master Hard Disk Error Fix Have you messed around with bios settings before? Primary Hard Disk Error Press F1 To Resume More about Leo.

yukic42 14:44 25 Jan 07 when i restart my pc now, it's come out a sound 'dig dag dig dag' from hardisk, then it say primary master hard disk error, press http://spamdestructor.com/hard-disk/primary-slave-hdd-error.php When no HDD are detached, but I have boot media in the DVD drive, the computer starts up quickly and normally, with no errors. He is running Windows XP. Even if you have no floppy drive the BIOS may still ask for it; it can't boot, so it has to ask for something. Primary Master Hard Disk Error Windows Xp

Such opinions may not be accurate and they are to be used at your own risk. I'd open the computer (if it's not a laptop, that is) and check the cabling, making sure that cables, both data and power, are securely seated and "pushed in" all the Article C3542 - October 23, 2008 « » Share this article with your friends: Leo A. check over here Switched it to master and it is fine.

Everytime i turn on my computer it show me the message Primary Master Hard Disk Error, although i put a window xp cd to reboot it... Primary Master Hard Disk Fail Windows Xp for realtek rtl8139(x) /8130/810x pci fast ethernet controller v2.13 PXE E61: media test failure, check cable PXE M0F: exiting PXE ROM reboot and select proper boot device or insert boot media yukic42 16:28 25 Jan 07 thanks a lot, i think the hard drive is broken down, so i have buy a new one.

This thread is now locked and can not be replied to.

If it works, which admittedly is not all that often in a case like this, it's cheap and fast. Press the F2 key to open System Diagnostics. PC Advisor Phones Smartphone reviews Best smartphones Smartphone tips Smartphone buying advice Smartphone news Smartphone deals Laptops Laptops reviews Laptops tips Best laptops Laptops buying advice Laptops news Tablets Tablet reviews Primary Master Hard Disk Error Windows 7 Detected!

Save and exit. For instructions on how to back up your data, refer to Backing Up Your Files (Windows 8) for computers running Windows 8, or Backing Up Your Files (Windows 7) for computers Windows 7 repair works differently than previous versions. http://spamdestructor.com/hard-disk/primary-slave-error.php Another good diagnostic step, once again with the power off, is to disconnect the hard drive, and then attempt a reboot just to see if there's additional failure information that can

You may also be interested in: Why do so many tech support solutions start with "reboot" or "turn it off"? I've never had to do the freezing method but I assume the trick is to wrap it tightly before putting it in the freezer. Newer Than: Search this thread only Search this forum only Display results as threads Useful Searches Recent Posts More... HP Customer Support Support Home Products Software and Drivers Forums Contact Support Search Select your Model Let HP find my products Identify now HP can identify most HP products and recommend

Several functions may not work. Report • #9 OtheHill May 4, 2011 at 13:43:01 Then I suggest you disconnect the old drive temporarily and do as princecorum suggested above. The computer is telling you, for whatever reason, it does not see a hard drive. pls...

Then it says to insert boot diskette in A. I re-started the computer once again and it stopped at the "Press F1 to Resume" part of the first screen. pls.. Are there different ways in which it could be dead (i.e., if it's a non-crucial part that can be replaced and then it would be working again OR if it there's

You might want to try and flash your BIOS (check the pc's manufacturer's website on how to do that). When I plug in three HDD + DVD drive, failure! While the content of the message varies, the result is usually the same: The startup process lags after auto-detecting the drives, then gives me this error. Report • #7 OtheHill May 4, 2011 at 12:57:17 How did you confirm you were booting from the new drive?

I didn't think it had anything to do with the OS as the system will still boot after some time - and sometimes multiple on/off cycles. Login now. It look for only what is wrong. Feb 12, 2015 #4 Tmagic650 TS Ambassador Posts: 17,233 +234 Yes, for 4 hard drives, that power supply may be failing now.

regards claire 0 Advertisements #2 Dwight Posted 18 January 2010 - 01:31 PM Dwight Member Member 480 posts Hi acute18, See if this will work for you.http://support.microsoft.com/kb/307852Dwight 0 #3 acute18 Posted