Home > Post Error > Post Error 1733

Post Error 1733

Select “F2” to add these physical & logical drive(s) to this controller. Audible Beeps: None Possible Cause: The controller flash operation was interrupted by a power cycle, or flash ROM is failing. If this message persists, you may need to replace the onboard battery. 163 Error Message Error Message: 163-Time & Date Not Set Audible Beeps: 2 long Possible Cause: Invalid time or What could be wrong? Source

Processor Power Error Message Error Message: WARNING: ProLiant Demand Based Power Management cannot be supported with the following processor configuration. Action: Install or reinstall DIMMs to support online spare configuration. 209 Error Message #3 Error Message: 209-Hot-add Memory Configuration - Boards must be installed sequentially. Illegal Opcode Error Message Error Message: Illegal Opcode - System Halted Audible Beeps: Audible Beeps: None Possible Cause: The server has entered the Illegal Operator Handler because of an unexpected event. The primary ROM is valid. http://www.accuzip.com/forum/viewtopic.php?t=627&sid=ed49a392ac9f2430189a71a3a8b12d77

Reset the port address to manually resolve the address conflict. Assembly will provide adequate cooling. Action: If you have recently added new hardware, remove it and see if the problem persists. Action: Replace the system board.

Assembly will provide adequate cooling. Once installed, the TPM becomes a permanent part of the system board. Action: Install or reinstall DIMMs to support mirrored mode. 209 Error Message #5 Error Message: 209-RAID Memory Configuration - Memory Sizes on boards X and Y do not match Audible Beeps: Action: Check the fans to be sure they are working.

Some configuration settings may have been lost and restored to defaults. If the problem persists, replace the failed cooling fans. 1611 Error Message #5 Error Message: 1611-Fan x Failure Detected (Fan Zone I/O) Audible Beeps: 2 short Possible Cause: Required fan is Audible Beeps: None Possible Cause: A hard drive SMART predictive failure condition is detected. http://answers.microsoft.com/en-us/windows/forum/windows8_1-gaming/error-1733-unable-to-re-install-microsoft-flight/85d82b05-38c6-4bcd-922b-1e35d079116f If you know of any error codes that I am displaying incorrectly or that aren't here.

Action: Reinstall DIMMs in proper order. Action: Replace each drive in the list or re-enable each drive in the list using one of the following methods: Use the Array Configuration Utility (all drive types). Next, type the following: regsvr32 "c:\program files (x86)\AccuZIP6 5.0\pdfcreactivex.dll" When both items register successfully, go back into AccuZIP6 and print your reports again._________________Chat with an AccuZIP6 technician weekdays from 7-4 PST Be sure that all software is installed properly.

If a ROM version exists that supports the processor: Power down the server. Floppy Drive Error Message Error Message: No Floppy Drive Present Audible Beeps: None Possible Cause: No diskette drive is installed or a diskette drive failure has occurred. Action: This configuration is not recommended because of controller memory requirements. Action: Correct the processor configuration.

For security reasons, only the customer can enable these features. this contact form Fan Solution Error Message #1 Error Message: Fan Solution Not Fully Redundant Audible Beeps: None Possible Cause: The minimum number of required fans is installed, but some redundant fans are missing WARNING: To avoid potential problems with the hardware or operating system, ALWAYS read the warnings and cautionary information in the server documentation before removing, replacing, reseating, or modifying any system components. Action: Do one of the following: If the drives will be removed at a later time, press F1 to continue ignoring the physical drives.

I want it to be able to find and pick up items. Abort the erase process using ACU (Array Configuration Utility). Action: Backup and restore the data on the drive. have a peek here Action: Install correctly matched DIMMs.

Audible Beeps: None Possible Cause: Required fans are missing or not spinning. Action: Be sure the keyboard and mouse are connected. top Non-numeric messages or beeps only Advanced Memory Error Message #1 Error Message: Advanced Memory Protection mode: Advanced ECC Audible Beeps: None Possible Cause: Advanced ECC support is enabled.

Add Stickiness To Your Site By Linking To This Professionally Managed Technical Forum.Just copy and paste the BBCode HTML Markdown MediaWiki reStructuredText code below into your site. Microsoft: Visual FoxPro

CAUTION: Only authorized technicians trained by HP should attempt to remove the system board. Either... ...the Assembly is not installed or multiple fans have failed. A single path was found to drives that were previously connected redundantly. Action: Run Insight Diagnostics and replace failed components as indicated. 224 Error Message Error Message: 224-Power Fault Detected - Flexible LOM 1 (Lan On Motherboard) Note: This error message applies to

See the product QuickSpecs or User Guide for supported memory configurations. 207 Error Message #9 Error Message: 207-Invalid Memory Configuration - Mismatched DIMMs within DIMM Bank... ...Memory in Board X, Bank Run the server setup utility. Like all the other codes out there. Check This Out Action: Check the iLO logs for details of the event.

Run Insight Diagnostics and replace failed components as indicated. 602 Error Message Error Message: 602-Diskette Boot Record Error Audible Beeps: None Possible Cause: The boot sector on the boot disk is Either... ...the Assembly is not installed or multiple fans have failed in the CPU zone. System Halted! Replace the memory board if problem persists. 210 Error Message #2 Error Message: 210-Memory Board Failure on board X Audible Beeps: 1 long, 1 short Possible Cause: A problem exists with

Action: This configuration is not recommended. HP is not liable for blocked data access caused by improper TPM use. See the product QuickSpecs or User Guide for supported memory configurations. 207 Error Message #6 Error Message: 207-Invalid Memory Configuration - Insufficient Timings on DIMM Audible Beeps: 1 long, 1 short Audible Beeps: None Description: The first DIMM socket in the pair is not populated.

Invalid Password Error Message #2 Error Message: Invalid Password - System Restricted! NMI Error Message #2 Error Message: NMI - Undetermined Source Audible Beeps: None Possible Cause: An NMI event has occurred. A ROM BIOS upgrade may be required. Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM security rivet.

Moderator: moderators Page 1 of 1 [ 7 posts ] Print view Previous topic | Next topic Author Message Novitas Post subject: Sound error?Posted: Sun May 17, 2009 3:11 Run the server setup utility to change the configuration. Action: For information on how to cable the device in a supported manner for dual-domain redundant path support, see the product user guide. 1742 Error Message Error Message: 1742-Slot z Drive If this message goes away after you remove the new hardware, there may be a problem with the expansion add-in board.

To read the Post error message on screen the video sub-system of the server must be working. Audible Beeps: None Possible Cause: Required cooling fans are missing or not spinning. I am converting from mp3 to ogg.